Fujitsu XG0224 User Manual page 179

XG Series User's Guide
The following commands spend 1 action for each.
If same <tos_value> is used, the commands use 1 action for them.
If same <dscp_value> is used, the commands use 1 action for them.
If same <queue_value> is used, the commands use 1 action for them.
- ether <number> qos aclmap <count> tos <tos_value> <acl>
- ether <number >qos aclmap <count> dscp <dscp_value> <acl>
- ether <number> qos aclmap <count> queue <queue_value> <acl>
- vlan <vid> qos aclmap <count> tos <tos_value> <acl>
- vlan <vid> qos aclmap <count> dscp <dscp_value> <acl>
- vlan <vid> qos aclmap <count> queue <queue_value> <acl>
- lan <number> ip dscp <count> acl <acl_count> <dscp_value>
The following commands spend 1 action for each.
If same <vid> is used, the commands use 1 action for them.
- vlan <vid> protocol <count> ether
- vlan <vid> protocol <count> llc
[XG0224 / XG0448 / XG0440DC / XG0440DCR]
Note 2.
If a queue is selected by <action> and if this queue has not been associated with the cos
value by the "qos cosmap"
Note 3.
This command is unavailable if the allowable upper limit for the device is exceeded.
The allowable upper limits are as follows.
• Upper limit based on "commands"
128 commands for the entire device.
Up to 128 commands can be set for the entire device, including the
"vlan qos aclmap" and "lan ip dscp"
1) "ether qos aclmap"
A smaller Ethernet port value has a higher priority among Ethernet ports.
2) "vlan qos aclmap" command
A smaller VLAN ID has a higher priority among VLANs.
3) "lan ip dscp"command
A smaller lan definition number has a higher priority among lans.
If up to 128 of "ether qos aclmap"
subsequent "vlan qos aclmap"
• Upper limit based on rule
128 rules for the entire device.
For the "ether qos aclmap",
number of rules to be used varies depending on the contents of the specified acl as
shown below.
The number of rules for each ACL is as follows.
- For ACL to set TCP or UDP
Result of multiplication between the number of source ports and the number of
destination ports for TCP or UDP
- For ACL to set ICMP
Result of multiplication between the number of ICMP TYPEs and the number of
ICMP CODEs for ICMP
- For ACL not to set TCP, UDP, or ICMP
1
command, the QoS processing is not executed.
commands.
command
commands have been defined for port ether1, the
and "lan ip dscp" command will be no longer applied.
"vlan qos aclmap" and
179
Chapter 5 Command Reference
"ether qos
"lan ip dscp" commands, the
VLAN Information Settings
aclmap",