Overview Of The Cli; Operating Environment For The Cli - Fujitsu XG0224 User Manual

XG Series User's Guide
2.1

Overview of the CLI

This section describes how to use the command line interface (CLI) for the XG Series.
2.1.1

Operating Environment for the CLI

There are two ways to access the device to run commands.
• Serial connection
Connect to the serial port of the device using RS232C cable via RJ45conversion cable.
The available terminal emulation type is VT100.
When initially connecting a terminal to the device, configure the serial port on the client side as shown below.
Item
Baud rate
Character size
Parity
Stop bits
Flow control
Emulation
Character set
Line feed code
• Remote connection via LAN port
Connect a terminal or host computer using a telnet client to the management LAN port of the device TCP port of 23
Is used for the default telnet connection
The following tables list the factory defaults.
Management-LAN [XG2600] and LAN Interface initial settings
Item
IP address
Subnet address
Telnet server initial settings
Item
Use telnet
Port number
Emulation
BackSpace key
Character set
To use the remote connection via the management-LAN port, use the "oob ip" command to configure the management-
LAN port for the device as below. [XG2600]
XG2600(config)# oob ip 192.168.1.1/24 3
XG2600(config)# commit
XG2600(config)# save
To use the remote connection via the LAN port 1, use the "lan ip" command to configure the management-LAN port
Setting value
9600 bps
8 bit
None
1 bit
None
VT100
ASCII
Transmission: CR (carriage return) only
Reception: LF is added
Setting value
None (must be set before using the LAN interface)
None (must be set before using the LAN interface)
Setting value
Enable
23 (TCP)
VT100/VT200/xterm
Delete
ASCII
38
Chapter 2 Using the CLI

Overview of the CLI