Network Management; Traffic Statistics; Snmp Agent - Fujitsu XG0224 User Manual

XG Series User's Guide
4.9

Network Management

4.9.1

Traffic Statistics

The device can display traffic statistics to analyze network operations such as traffic bytes, errors, etc.
The following are the Traffic Statistics the device provides.
• Displays traffic information on outgoing and incoming frames for each port.
• Displays traffic information on incoming frames by frame size range for each port.
• Displays traffic information on incoming frames for each VLAN.
• Displays incoming traffic information by QoS priority for each port.
• Displays information related to data flow for each port.
• Displays information about errors that occur during transmission/reception for each port.
To display traffic statistics, monitor and show commands are provided.
• "show ether utilization"
Display the usage ratio (or utilization) information of Ethernet physical ports.
• "show ether statistics"
Display the statistics of Ethernet physical ports.
4.9.2

SNMP Agent

SNMP (Simple Network Management Protocol) is a protocol that monitors and manages devices on a network.
The device supports the SNMP (v1/v2c/v3) function to collect management information blocks (MIBs) from a remote
network manager (SNMP manager).
For the MIBs supported, refer to Appendix B. The device can be configured for up to 16 SNMP managers and up to 16
SNMP trap destinations (8 for v1/v2c, 8 for v3).
To configure the SNMP agent, carry out the following procedures in "admin" Operation mode.
XG2600# configure
XG2600(config)#snmp service on
XG2600(config)#snmp agent contact
SYSTEM-CONTAC
XG2600(config)#snmp agent location
SYSTEM-LOCATION
XG2600(config)#snmp agent address A.B.C.D
XG2600(config)# snmp manager 0 A.B.C.D
COMMUNIT-YNAME v2c disable
XG2600(config)# snmp user 0 name USERNAME
XG2600(config)# snmp user 0 address 0 A.B.C.D
XG2600(config)# snmp user 0 notification 0 A.B.C.D
XG2600(config)# snmp user 0 auth md5
auth_password
XG2600(config)# snmp user 0 priv des priv_password
command
(show ether statistics detail) command
Command
Chapter 4 Switch Functions and their Configuration
Switch to Configuration mode.
Enable SNMP function.
Set the swith's contact (SYSTEM-CONTACT).
Set the swith's location (SYSTEM-LOCATION).
Set the SNMP agent address. This setting is also used for the
local address at trap transmission.
Make sure to set it when using the SNMP agent function.
Set the IP address (host name) of the SNMP manager, the
community name, sending SNMPv2 traps, and disabling writing.
if the SNMP trap notification is enabled.
Set a SNMP v3 user name.
Set a SNMP v3 host address.
Set a SNMP v3 trap notification host address.
Set the authentication protocol and password for SNMP v3.
Set the encryption protocol and password for SNMP v3.
83
Task

Network Management