Time Of Command Execution Display Function; Command History Function - Fujitsu XG0224 User Manual

XG Series User's Guide
• To disable the configuration hierarchy function: Press CTRL + G.
The following message is displayed and the configuration hierarchy function is disabled. Information which has been
partially entered will be discarded.
<NOTICE> The configuration directory mode is disabled.
A command execution example is shown below.
Command
# configure
(config)# lan 0 ip address 192.168.1.1/24 3
(config-lan-0-ip)#
(config-lan-0-ip)# show
address 192.168.1.1/24 3
service server
info address 192.168.1.100/24 32
(config-lan-0-ip)# save
(config-lan-0-ip)# top
(config)#

2.2.1.8 Time of command execution display function

The time of command execution display function allows you to display the time when the execution of a command starts.
This function is useful when a command execution log is being recorded during operations.
To enable the time of command execution display function, use the terminal timestamp command.
Although you can check command execution time with the show logging command, execution time is only displayed for
commands recorded in the command execution history. You can also use the terminal prompt command to display the date
and time in the prompt string However, this is not the time when a command was executed but the time when the prompt
was displayed.

2.2.1.9 Command history function

The command history function allows you to record command execution history and re-execute commands using this
history. You can also redisplay commands and replace commands in the history.
You can set the number of lines in the command history using a terminal logging command.
You can also press CTRL + P and CTRL + N to sequentially display the command history items, and re-execute or re-edit and
Note
execute a displayed command.
"2.2.1.10 List of shell key bindings", p.
Reference
The following explains how to re-execute and redisplay commands.
You can use the history specifier and display specifier together with command character string replacement.
(Change to configuration mode.)
(Run configuration command.)
(Hierarchy level is displayed at the command prompt.)
(Display configuration following the current level.)
(Enter the command name and run the command.)
(Move to the top level.)
52.
48
Chapter 2 Using the CLI
Using the CLI