Quality Of Service (Qos) - Fujitsu XG0224 User Manual

XG Series User's Guide
4.7

Quality of Service (QoS)

The device provides Quality of Service (QoS) that is based on the IEEE802.1p standard.
The device QoS determines the priority of frames at the ingress side using VLAN tag (including priority tag) or a port's
default priority. Their priorities are mapped to 8 output queues.
The queues are processed in the order of the QoS priority precedence.
The device priorities available are:
• Default priority
Set a default priority of 0 to 7 for each port.
For frames whose priority was not set (VLAN-untagged frames), the default priority is assigned according to the value
of the frame.
• Mapping to output queues
The device is equipped with 8 output queues with different levels (0 to 7). Frames are transmitted in order of output
queue priority.
Each priority is mapped to a specified output queue.
To set the default priority and output queue mapping, carry out the following procedure in "admin" Operation mode.
• XG2600
XG2600# configure
XG2600(config)# ether 1-8 qos priority (0-7)
XG2600(config)# ether 1-8 qos prioritymap (0-7) (0-7)
XG2600(config)# save
XG2600(config)# reset
• XG0224 / XG0448 / XG0440DC / XG0440DCR
XG0224# configure
XG0224(config)# ether 1-8 qos priority (0-7)
XG0224(config)# qos cosmap (0-7) (0-7)
XG0224(config)# save
XG2600(config)# reset
Command
Command
Chapter 4 Switch Functions and their Configuration
Switch to Configuration mode.
Set a default priority for frames whose priority was not set
(VLANuntagged frame) when received.
Set the level of output queue to map to each frame that has a
priority value.
Save the configuration.
Reset the device.
Switch to Configuration mode.
Set a default priority for frames whose priority was not set
(VLANuntagged frame) when received.
Set the level of output queue to map to each frame that has a
priority value.
Save the configuration.
Reset the device.
76
Task
Task

Quality of Service (QoS)