Fujitsu XG0224 User Manual page 178

XG Series User's Guide
The number of masks that each command use depends on applied ACL.
When Multiple ACL are applied, the number of masks amount to sum total, and
depends on ACLs the number of masks amount to less than sum total.
The following is the number of masks for ACL.
"acl mac"
define LSAP of llc
not define LSAP of llc
"acl vlan"
not define src IP address
not define tos/dscp value
not define tos/dscp value
define src IP address
not define dst IP address
define dst IP address
use same netmask for src and dst IP address
not define tos/dscp value
not define tos/dscp value
use different netmask for src and dst IP address
The following is the number of masks for
"vlan protocol" definition
define vlan protocol ipv4
define vlan protocol ipv6
define vlan protocol <count> ether
define vlan protocol <count> llc
• Upper limit based on "actions"
16 actions for the entire device.
Up to16 actions can be set for the entire device, including the
qos aclmap", "lan ip dscp",
The priority for each command is as follows.
1) "vlan protocol" commands
2) "ether qos aclmap"
A smaller Ethernet port number has a higher priority among Ethernet ports.
3) "vlan qos aclmap" command
A smaller VLAN ID has a higher priority among VLANs.
4) "lan ip dscp" command
A smaller lan definition number has a higher priority among lans.
The following commands spend 1 action regardless of multiple use.
- vlan <vid> protocol ipv4
- vlan <vid> protocol ipv6
ACL
"vlan protocol"
"vlan protocol" commands.
command
178
Chapter 5 Command Reference
number of masks
3
1
1
1
3
1
1
3
3
command.
number of masks
3
1
1
1
"ether qos aclmap", "vlan
VLAN Information Settings