Connecting A Kvm-Ia To Each Target Device; Connecting Local Peripheral Devices; Verifying Ethernet Connections; Configuring The Kvm S3 Client - Fujitsu series3-1621 User Giude

Installation
mouse on the local ports or the keyboard will not initialize correctly. You cannot
connect a DVI or EGA monitor to the KVM s3-1621 appliance.
Connect one end of a Cat 5 patch cable (4-pair, up to 10 meters) into any ARI port,
and connect the other end into the RJ-45 connector of a KVM-IA.
Connect the KVM-IA into the correct ports on the rear of the target device. Repeat
this procedure for all target devices that are to be connected to the KVM s3-1621
appliance.
Connect a Cat 5 patch cable from the Ethernet network into the LAN port on the
rear panel of the KVM s3-1621 appliance. Network users will access the appliance
through this port.
If you are configuring the KVM s3-1621 appliance using the console menu
interface, connect a computer running terminal emulation software to the IOIOI port
on the rear panel of the appliance, using the supplied straight serial cable. The
terminal should be set to 9600 bits per second (bps), 8 bits, 1 stop bit, no parity, and
no flow control. Otherwise, proceed to the next step.
Turn on each target flag and then turn on the KVM s3-1621 appliance. After
approximately one minute, the appliance completes initialization and opens the
OSCAR graphical user interface Free tag on the local port monitor.
Use the KVM s3 Client to configure your KVM s3-1621 appliance. See the KVM s3
Client Installation and User's Guide for detailed instructions.
2.5.1

Connecting a KVM-IA to each target device

Attach the color-coded connectors of the KVM-IA to the keyboard, monitor, and
mouse ports on the first target device that you connect to the KVM s3-1621 appli-
ance.
Attach one end of the Cat 5 cable to the RJ-45 connector on the KVM-IA.
Connect the other end of the Cat 5 cable to any ARI port on the rear of the KVM s3-
1621 appliance.
Repeat steps 1 to 3 for all target devices that you are attaching.
2.5.2

Connecting local peripheral devices

Connect a keyboard, monitor, and mouse to each set of color-coded ports on the
rear of the KVM s3-1621 appliance.
Bundle and label the cables for easy identification.
2.6

Verifying Ethernet connections

The Ethernet connection has two LEDs. The green LED on the right is the Link indicator.
It is lit when a valid connection to the network is established, and it flashes when there is
activity on the port. The amber/green LED on the left indicates that you are
communicating at 100 Mbps (amber) or 1000 Mbps (green) when using the Ethernet
connection.
2.7

Configuring the KVM s3 Client

See the KVM s3 Client User Guide included on the CD with the software.
12
590-591-609D