Fujitsu XG0224 User Manual page 563

XG Series User's Guide
(1)-1
In addition to operation (1), the relevant route is added or deleted with the route
change for this device and the neighboring routers.
(2)
The communication via the relevant logical interface is interrupted briefly.
(3)
The relevant Ethernet port is linked down or linked up.
(3)-LA
If changed from "static" to "passive" or "active" or vice versa, the relevant Ethernet
port is linked down or linked up.
If changed from "passive" to "active" or vice versa, the operation is the same as (1).
(3)-1
If changed from "online" to "offline", the relevant Ethernet port is linked down or
linked up.
If changed from "offline" to "online", the operation is the same as (1).
(4)
To enable the settings, the device needs to be restarted (or reset).
(5)
The port which is set to be target port, is used for monitoring function only, and
can not be used for forwarding.
(6)
Forwarding frames is interrupted briefly.
*1
The registered learning table may be deleted.
*2
If changed the VLAN ID which used by system for the Management Port, the
communication via the Management Port is interrupted briefly, and the TCP
session is closed.
*3
If the bridge network configuration is changed, the registered learning table may
be deleted or the communication via the relevant interface may be interrupted
briefly.
*4
If configured to use ACL Filter/QoS, the forwarding frames is interrupted briefly.
*5
If there are "vlan protocol" definitions over 16, the definition, the VLAN and the
ports belong to the VLAN are invalid.
*6
The system reconfigure the Protocol VLAN and the ACL Filter/QoS, the
communication via the all ports is interrupted briefly.
563
Chapter 5 Command Reference
Effect by "commit" Command Execution