Aaa Radius Client Server-Info Auth Deadtime - Fujitsu XG0224 User Manual

XG Series User's Guide

5.13.3.7 aaa radius client server-info auth deadtime

Function
Available Model
Syntax
Options
Use Mode
Explanation
Default
Set a recovery standby time.
XG0224 / XG0448 / XG0440DC / XG0440DCR / XG2600
aaa [<group_id>] radius client server-info auth [<number>] deadtime <deadtime>
<group_id>
• Group ID
Specify a group ID with a serial decimal value.
<number>
• Server definition number
Specify the definition number of the remote device with a decimal value.
The default is 0.
<deadtime>
• Recovery standby time
Specify a time period required to automatically restore the RADIUS server to the alive
state after it was placed into the dead state.
The unit shall be d (day), h (hour), m (minute), or s (second).
The allowable range is as follows:
0 to 86400 (seconds):
Specifying "0s" will not automatically restore the RADIUS server to the alive state.
Configuration mode (admin class)
If the RADIUS server does not respond after the response wait time set in the
client retry" command lapsed, it will be placed in the dead state and set to the lowest
priority. Once the RADIUS server is placed in the dead state, it will remain disabled as
long as an alive server is active. Set a wait time to automatically recover the server from
the dead state to the alive state according to the priority setting.
To recover from the dead state to the alive state, one of the following conditions must be
satisfied.
• When the set time has elapsed:
• When a response has been returned from the RADIUS server in the dead state, to
which some packets were sent, after all the available servers were placed into the dead
state; or
• When the dead state has been manually recovered with the
command.
It is assumed that the server is not recovered automatically.
aaa radius client server-info auth deadtime 0s
258
Chapter 5 Command Reference
"aaa radius
"radius recovery"
AAA Information Settings