Fujitsu XG0224 User Manual page 134

XG Series User's Guide
Note 2.
The packet filtering default value is "pass".
No packets are filtered if only "pass" is set in <action>.
[XG2600]
Note 3.
"acl mac llc" definitions can not filter llc frames with the VLAN tag.
Note 4.
This command is unavailable if the allowable upper limit for the device is exceeded.
The allowable upper limits are as follows.
• Upper limit based on "commands"
64 commands for the entire device.
Up to 64 commands can be set for the entire device, including the
"vlan macfilter", "lan ip filter",
commands.
The priority for each command is as follows.
1) "ether macfilter" command
A smaller Ethernet port number has a higher priority among Ethernet ports.
2) "vlan macfilter" command
A smaller VLAN ID has a higher priority among VLANs.
3) "lan ip filter" command
A smaller lan definition number has a higher priority among lans.
4) "ether qos aclmap"
A smaller Ethernet port number has a higher priority among Ethernet ports.
5) "vlan qos aclmap" command
A smaller VLAN ID has a higher priority among VLANs.
6) "lan ip dscp" command
A smaller lan definition number has a higher priority among lans.
• Upper limit based on "masks"
64 masks for the entire device.
Up to 64 masks can be set for the entire device, including the
macfilter", "lan ip filter",
protocol" commands.
The priority for each command is as follows.
"ether qos aclmap",
command
"ether qos aclmap", "vlan qos
134
Chapter 5 Command Reference
"ether macfilter",
"vlan qos aclmap", "lan ip dscp"
"ether macfilter",
aclmap", "lan ip dscp",
Port Information Settings
"vlan
"vlan