Loopback Detection Commands - D-Link DES-1228/ME Reference Manual

The Loopback Detection commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table:
Command
config loopdetect
config loopdetect
ports
enable loopdetect
disable loopdetect
show loopdetect
show loopdetect ports
config loopdetect trap
Each command is listed, in detail, in the following sections:
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameters
{ recover_timer [ 0 | <value 60-1000000> ] | interval < value 1-32767> } (1)
[ <portlist> | all ] state [ enable | disable ]
[ <portlist> | all ]
[ none | loop_detected | loop_cleared | both ]
L D
OOPBACK
347
C
ETECTION OMMANDS
42