D-Link DES-1228/ME Reference Manual page 69

Example Usage:
To display the list of trust hosts:
DES-1228/ME:5#show trusted_host
Command: show trusted_host
Management Stations
IP Address/Netmask
-----------------------
10.53.13.94/32
Total Entries: 1
DES-1228/ME:5#
enable snmp traps
Purpose
Syntax
Description
Parameters
Restrictions
To enable SNMP trap support:
DES-1228/ME:5#enable snmp traps
Command: enable snmp traps
Success.
DES-1228:5#
enable snmp authenticate_traps
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable SNMP authentication trap support:
DES-1228/ME:5#enable snmp authenticate_traps
Command: enable snmp authenticate_traps
Success.
DES-1228/ME:5#
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Used to enable SNMP trap support.
enable snmp traps
The enable snmp traps command is used to enable SNMP trap support on the switch.
None.
Only Administrator level or Operator level users can issue this command.
Used to enable SNMP authentication failure trap support..
enable snmp authenticate_traps
This command is used to enable snmp authenticate_traps command enables
SNMP authentication failure trap support.
None.
Only Administrator level or Operator level users can issue this command.
65