D-Link DES-1228/ME Reference Manual page 357

config loopdetect trap
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set trap mode for loopback detection:
DES-1228/ME:5# config loopdetect trap both
Command: config loopdetect trap both
Success.
DES-1228/ME:5#
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Used to configure loopback detection traps.
config loopdetect trap [ none | loop_detected | loop_cleared | both ]
This command is used to specify the trap modes for loop detection.
none – A trap is not sent in either case.
loop_detected - Trap is sent when the loop condition is detected.
loop_cleared - Trap is sent when the loop condition is cleared.
both – A trap is sent in either case.
Only Administrator level, Operator level or Power User level users can issue this
command.
353