D-Link DES-1228/ME Reference Manual page 224

DES-1228/ME:5#show access_profile
Command: show access_profile
Access Profile Table
================================================================================
Profile ID: 101
================================================================================
Masks Option
VLAN
---------------- --------------- --------------- ---- ----
0xFFF
================================================================================
Total Profile Entries: 1
Total Used Rule Entries: 0
Total Unused Rule Entries: 256
DES-1228/ME:5#
create cpu access_profile
Purpose Used to create an access profile specifically for CPU Interface Filtering on the Switch and to
define which parts of each incoming frame's header the Switch will examine. Masks can be
entered that will be combined with the values the Switch finds in the specified frame header
fields. Specific values for the rules are entered using the config cpu access_profile command,
below.
Syntax create cpu access_profile profile_id <value 1-3> [ethernet {vlan | source_mac <macmask> |
destination_mac <macmask> | 802.1p | ethernet_type} (1) | ip { vlan | source_ip_mask
<netmask> | destination_ip_mask <netmask> | dscp | [ icmp {type | code } | igmp {type } | tcp
{src_port_mask <hex 0x0-0xffff> | dst_port_mask <hex 0x0-0xffff> | flag_mask [ all | {urg | ack |
psh | rst | syn | fin} (1) ] } | udp {src_port_mask <hex 0x0-0xffff> | dst_port_mask <hex 0x0-0xffff>}
protocol_id_mask <hex 0x0-0xff> {user_define_mask <hex 0x0-0xffffffff>} ]} (1) | ipv6 {[{ class |
flowlabel | source_ipv6_mask <ipv6mask> | destination_ipv6_mask <ipv6mask>]} (1) ]
Description This command is used to create an access profile used only for CPU Interface Filtering. Masks
can be entered that will be combined with the values the Switch finds in the specified frame
header fields. Specific values for the rules are entered using the config cpu access_profile
command, below.
profile_id <value 1-3> − Enter an integer between 1 and 3 that is used to identify the CPU access
Parameters
profile to be created with this command.
ethernet − Specifies that the Switch will examine the layer 2 part of each packet header.
vlan − Specifies that the Switch will examine the VLAN part of each packet header.
source_mac <macmask> − Specifies to examine the source MAC address mask.
destination_mac <macmask> − Specifies to examine the destination MAC address mask.
802.1p − Specifies that the Switch will examine the 802.1p priority value in the frame's header.
ethernet_type − Specifies that the Switch will examine the Ethernet type value in each frame's
header.
ip − Specifies that the Switch will examine the IP fields in each frame's header.
vlan − Specifies a VLAN mask.
source_ip_mask <netmask> − Specifies an IP address mask for the source IP address.
destination_ip_mask <netmask> − Specifies an IP address mask for the destination IP address.
dscp − Specifies that the Switch will examine the DiffServ Code Point (DSCP) field in each
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Source IP Dest. IP
20.0.0.0 10.0.0.0
Type: IPv4 Frame Filter - ICMP
DSCP Prot
ICMP
220