D-Link DES-1228/ME Reference Manual page 246

config arpentry
Example Usage:
To configure a static ARP entry for the IP address 10.48.74.12 and MAC address 00:50:BA:00:07:36:
DES-1228/ME:5#config arpentry 10.48.74.12 00-50-BA-00-07-36
Command: config arpentry 10.48.74.12 00-50-BA-00-07-36
Success.
DES-1228/ME:5#
delete arpentry
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To delete an entry of IP address 10.48.74.121 from the ARP table:
DES-1228/ME:5#delete arpentry 10.48.74.121
Command: delete arpentry 10.48.74.121
Success.
DES-1228/ME:5#
config arp_aging time
Purpose
Syntax
Description
Parameters
Restrictions
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
can issue this command.
Used to delete a static entry into the ARP table.
delete arpentry {[<ipaddr> | all]}
This command is used to delete a static ARP entry, made using the
create arpentry command above, by specifying either the IP address
of the entry or all. Specifying all clears the Switch's ARP table.
<ipaddr> − The IP address of the end node or station.
all − Deletes all ARP entries.
Only Administrator level, Operator level or Power User level users
can issue this command.
Used to configure the age-out timer for ARP table entries on the
Switch.
config arp_aging time <value 0-65535>
This command is used to set the maximum amount of time, in
minutes, that an ARP entry can remain in the Switch's ARP table,
without being accessed, before it is dropped from the table.
time <value 0-65535> − The ARP age-out time, in minutes. The
value may be set in the range of 0-65535 minutes with a default
setting of 20 minutes.
Only Administrator level, Operator level or Power User level users
can issue this command.
242