D-Link DES-1228/ME Reference Manual page 226

delete cpu access_profile
Syntax
Description
Parameters
Restrictions
Example usage:
To delete the CPU access profile with a profile ID of 1:
DES-1228/ME:5#delete cpu access_profile profile_id 1
Command: delete cpu access_profile profile_id 1
Success.
DES-1228/ME:5#
config cpu access_profile
Purpose Used to configure a CPU access profile used for CPU Interface Filtering and to define
specific values that will be used to by the Switch to determine if a given packet should be
forwarded or filtered. Masks entered using the create cpu access_profile command will be
combined, using a logical AND operational method, with the values the Switch finds in the
specified frame header fields. Specific values for the rules are entered using the config
cpu access_profile command, below.
Syntax config cpu access_profile profile_id <value 1-3> [add access_id <value 1-5>[ethernet {vlan
<vlan_name 32> | source_mac <macaddr> | destination_mac <macaddr > | 802.1p <value
0-7> | ethernet_type <hex 0x0-0xffff>} (1) | ip{vlan <vlan_name 32> | source_ip <ipaddr> |
destination_ip <ipaddr> | dscp <value 0-63> | [icmp {type <value 0-255> | code <value 0-
255>} | igmp {type <value 0-255>} | tcp {src_port <value 0-65535> | dst_port <value 0-
65535> flag [all { urg | ack | psh | rst | syn | fin} (1) ]} | udp {src_port <value 0-65535> |
dst_port <value 0-65535>} | protocol_id <value 0-255> {user_define <hex 0x0-0xffffffff>}]}
(1) | ipv6 {[{ class <value 0-255> | flowlabel <hex 0x0-0xfffff>} | source_ipv6 <ipv6addr>|
destination_ipv6 <ipv6addr>]}]port [<portlist> | all ][ permit | deny] | delete access_id
<value 1-5>]
Description This command is used to configure a CPU access profile for CPU Interface Filtering and to
enter specific values that will be combined, using a logical AND operational method, with
masks entered with the create cpu access_profile command, above.
Parameters
add access_id <value 1-5> − Adds an additional rule to the above specified access profile.
The value is used to index the rule created.
Parameters
ethernet − Specifies that the Switch will look only into the layer 2 part of each packet.
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
delete cpu access_profile profile_id <value 1-3>
This command is used to delete a previously created CPU access profile.
profile_id <value 1-3> − Enter an integer between 1 and 3 that is used to identify
the CPU access profile to be deleted with this command. This value is assigned to
the access profile when it is created with the create cpu access_profile command.
Only Administrator level, Operator level or Power User level users can issue this
command.
profile_id <value 1-3> − Enter an integer used to identify the access profile that will be
configured with this command. This value is assigned to the access profile when it
is created with the create access_profile command. The profile ID sets the relative
priority for the profile and specifies an index number that will identify the access
profile being created with this command. Priority is set relative to other profiles
where the lowest profile ID has the highest priority.
vlan <vlan_name 32> − Specifies that the access profile will apply to only to this VLAN.
source_mac <macaddr> − Specifies that the access profile will apply to this source
MAC address.
222