Loopback Detection Commands - D-Link DES-3010F Command Line Interface Manual

The Loopback Detection commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
enable loopdetect
disable loopdetect
config loopdetect
show loopdetect
config loopdetect ports
show loopdetect ports
Each command is listed, in detail, in the following sections.
enable loopdetect
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the Loopback Detection function, globally, on the Switch:
disable loopdetect
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the Loopback Detection function, globally, on the Switch:
DES-3000 Series Layer 2 Switch CLI Reference Manual
L
Parameters
[recover_timer [0 | <value 60-1000000>] | interval <value 1-32767>]
[<portlist> | all] state [enable | disable]
{<portlist>}
Used to globally enable the Loopback Detection function on the
switch.
enable loopdetect
This command, along with the disable loopdetect command will
enable and disable the Loopback Detection function on the switch,
without adjusting configurations.
None.
Only administrator-level users can issue this command.
DES-3026:4#enable loopdetect
Command: enable loopdetect
Success.
DES-3026:4#
Used to globally disable the Loopback Detection function on the
switch.
disable loopdetect
This command, along with the enable loopdetect command will
enable and disable the Loopback Detection function on the switch,
without adjusting configurations.
None.
Only administrator-level users can issue this command.
D
OOPBACK ETECTION
72
11
C
OMMANDS