D-Link DES-1228/ME Reference Manual page 100

create syslog host
Purpose
Used to create a new syslog host.
Syntax create syslog host <index 1-4> {severity [informational | warning | all] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> | ipaddress
[<ipaddr>] | state [enable | disable] }
Description This command is used to create a new syslog host.
<index 1-4> − Specifies that the command will be applied to an index of hosts. There are four
Parameters
available indexes, numbered 1 through 4.
severity − Severity level indicator. These are described in the following:
Bold font indicates that the corresponding severity level is currently supported on the Switch.
Numerical
Code
0
1
2
3
4
5
6
7
Numerical
Code
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Severity
Emergency: system is unusable
Alert: action must be taken immediately
Critical: critical conditions
Error: error conditions
Warning: warning conditions
Notice: normal but significant condition
Informational: informational messages
Debug: debug-level messages
Facility
96