Vlan Trunking Commands - D-Link DES-1228/ME Reference Manual

The VLAN Trunking commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
enable vlan_trunk
disable vlan_trunk
config vlan_trunk ports
show vlan_trunk
Each command is listed, in detail, in the following sections.
enable vlan_trunk
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the VLAN Trunk:
DES-1228/ME:5#enable vlan_trunk
Command: enable vlan_trunk
Success.
DES-1228/ME:5#
disable vlan_trunk
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the VLAN Trunk:
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameters
[<portlist>|all] state [enable|disable]
Used to enable the VLAN trunk function.
enable vlan_trunk
When the VLAN trunk function is enabled, the VLAN trunk ports shall be
able to forward all tagged frames with any VID.
None.
Only Administrator level, Operator level or Power User level users can
issue this command.
Used to disable the VLAN trunk function.
disable vlan_trunk
This command is used to disable the VLAN trunk function.
None.
Only Administrator level, Operator level or Power User level users can
issue this command.
VLAN T
RUNKING
301
36
C
OMMANDS