D-Link DES-1228/ME Reference Manual page 185

Example usage:
To configure IGMP snooping data driven learning's maximum learned entry value:
DES-1228/ME:5# config igmp_snooping data_driven_learning max_learned_entry
1
Command: config igmp_snooping data_driven_learning max_learned_entry 1
Success.
DES-1228/ME:5#
clear igmp_snooping data_driven_group
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete all the groups learned by data-driven :
DES-1228/ME:5# clear igmp_snooping data_driven_group all
Command: clear igmp_snooping data_driven_group all
Success.
DES-1228/ME:5#
show igmp_snooping host
Purpose
Syntax
Description
Parameters
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Used to delete the IGMP snooping group learned by data driven.
clear igmp_snooping data_driven_group [ [vlan_name <vlan_name
32> | vlanid <vlanid> ] [ all | <ipaddress>] | all ]
This command is used to delete the IGMP snooping group learned by
data driven.
Note that this command is currently only for layer 2 switches.
<vlan_name 32> − Specifies the VLAN name.
<vlanid> − Specifies the VLAN ID.
all − Delete all data-driven entries.
<ipaddr> − Specifies the IP Address.
all − Delete all IP addresses.
Only Administrator level, Operator level or Power User level users
can issue this command.
Used to display the IGMP host that has joined groups on specific
ports or specific VLANs.
show igmp_snooping host {[vlan_name <vlan_name 32> | vlanid
<vidlist> | ports <portlist> | group <ipaddr>] }
This command is used to display the IGMP host that has joined
groups on specific ports or specific VLANs.
<vlan_name 32> − Specifies the VLAN to display the host
information. If a VLAN or port is not specified, all joining hosts will be
displayed.
<vlanid>− Specifies the VLAN ID.
<portlist>− Specifies the list of ports to display the host information. If
a VLAN or port is not specified, all joining hosts will be displayed.
<ipaddr> − Specifies the IP address of a group to display the host
information.
181