D-Link DES-1228/ME Reference Manual page 353

config loopdetect ports
Purpose Used to configure the loopback detection function for the port on the Switch.
Syntax config loopdetect ports [ <portlist> | all ] state [ enable | disable ]
Description This command is used to set up the loopback detection function for port configuration on the
Switch.
Parameters <portlist> – Specifies a range of ports to be configured for loopback detection status.
all – Apply setting to all ports.
state - Allows loopback detection to be enabled or disabled for the ports specified in the port list.
The default is disabled.
enable – Set port loopback detection status to enable.
disable - Set port loopback detection status to disable.
Restrictions Only Administrator level, Operator level or Power User level users can issue this command.
Example usage
To set the loopback detection status to enabled:
DES-1228/ME:5# config loopdetect ports 1-5 state enable
Command: config loopdetect ports 1-5 state enable
Success.
DES-1228/ME:5#
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
349