D-Link DES-1228/ME Reference Manual page 78

download
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To download a configuration file:
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Used to download and install new firmware or a Switch
configuration file from a TFTP server.
[firmware_fromTFTP [<ipaddr> | <ipv6addr>] <path_filename 64>
image_id <value 1-2> | cfg_fromTFTP [<ipaddr> | <ipv6addr>]
<path_filename 64> {config_id <value 1-2> | increment}]
This command is used to download a new firmware or a Switch
configuration file from a TFTP server.
firmware_fromTFTP - Download and install new firmware on the
Switch from a TFTP server.
cfg_fromTFTP - Download a switch configuration file from a TFTP
server.
<ipaddr> - The IP address of the TFTP server.
<ipv6addr> - The IPv6 address of the TFTP server.
<path_filename> - The DOS path and filename of the firmware or
switch configuration file on the TFTP server. For example,
C:\1228.had.
image_id <value 1-2> - Specify the working section ID. The Switch
can hold two firmware versions for the user to select from, which
are specified by section ID.
increment - Allows the download of a partial switch configuration
file. This allows a file to be downloaded that will change only the
switch parameters explicitly stated in the configuration file. All other
switch parameters will remain unchanged.
config_id <value 1-2> - Specifies which cfg file ID. if cfg ID is not
specified, it refers to the boot_up CFG file.
The TFTP server must be on the same IP subnet as the Switch.
Only Administrator level, Operator level or Power User level users
can issue this command.
74