D-Link DES-1228/ME Reference Manual page 319

config lldp message_tx_interval
Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To change the packet transmission interval:
DES-1228/ME:5# config lldp message_tx_interval 30
Command: config lldp message_tx_interval 30
Success.
DES-1228/ME:5#
config lldp message_tx_hold_multiplier
Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To change the multiplier value:
DES-1228/ME:5# config lldp message_tx_hold_multiplier 3
Command: config lldp message_tx_hold_multiplier 3
Success.
DES-1228/ME:5#
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Used to change the packet transmission interval.
config lldp message_tx_interval <sec 5-32768>
This command is used to control how often active ports retransmit
advertisements to their neighbors.
message_tx_interval - Changes the interval between consecutive
transmissions of LLDP advertisements on any given port. The range is
from 5 to 32768 seconds. The default setting is 30 seconds.
Only Administrator level, Operator level or Power User level users can
issue this command.
This command is used to configure the message hold multiplier.
config lldp message_tx_hold_multiplier <int 2-10>
This command is a multiplier on the msgTxInterval that is used to
compute the TTL value of txTTL in an LLDPDU. The TTL will be carried
in the LLDPDU packet. The lifetime will be the minimum of 65535 and
(message_tx_interval * message_tx_hold_multiplier). At the partner
switch, when the Time-to-Live for a given advertisement expires, the
advertised data is deleted from the neighbor switch's MIB.
message_tx_hold_multiplier - The range is from 2 to 10. The default
setting 4.
Only Administrator level, Operator level or Power User level users can
issue this command.
315