Vlan Commands - D-Link DES-1228/ME Reference Manual

The VLAN commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table:
Command
create vlan
delete vlan
create vlan vlanid
delete vlan vlanid
config vlan vlanid
config vlan
enable pvid
disable pvid
show pvid
config gvrp
enable gvrp
disable gvrp
show vlan
show gvrp
Each command is listed, in detail, in the following sections:
create vlan
Purpose
Syntax
Description
Parameters
Restrictions
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameters
<vlan_name 32> tag <vlanid 1-4094> {advertisement}
<vlan_name 32> | vlanid <vidlist>
<vidlist> {advertisement}
<vidlist>
<vidlist> { [ add [ tagged | untagged | forbidden ] | delete ]
<portlist> | advertisement [ enable | disable ] | name <vlan_name
32>} (1)
<vlan_name 32> {[add [tagged | untagged | forbidden] | delete]
<portlist> | advertisement [enable | disable]} (1)
auto_assign
auto_assign
auto_assign
[<portlist> | all] {state [enable | disable] | ingress_checking [enable
| disable] | acceptable_frame [tagged_only | admit_all] | pvid
<vlanid 1-4094>} (1)
{[<vlan_name 32> | vlanid <vidlist> | ports <portlist>]}
{<portlist>}
Used to create a VLAN on the Switch.
create vlan <vlan_name 32> tag <vlanid 1-4094> {advertisement}
This command allows the user to create a VLAN on the Switch.
<vlan_name 32> − The name of the VLAN to be created.
<vlanid 1-4094> − The VLAN ID of the VLAN to be created. Allowed
values = 1-4094
advertisement − Specifies that the VLAN is able to join GVRP. If
this parameter is not set, the VLAN cannot be configured to have
forbidden ports.
Each VLAN name can be up to 32 characters. Up to 4094 static
VLANs may be created per configuration. Only Administrator level,
Operator level or Power User level users can issue this command.
151
16
VLAN C
OMMANDS