D-Link DES-1228/ME Reference Manual page 70

DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
enable snmp linkchange_traps
Purpose Used to configure the sending of linkchange traps. .
Syntax
enable snmp linkchange_traps
Description This command is used to enable/disable snmp link change traps.
Parameters None.
Restrictions Only Administrator level or Operator level users can issue this command.
To enable SNMP linkchange trap support on the Switch:
DES-1228/ME:5# enable snmp linkchange_traps
Command: enable snmp linkchange_traps
Success.
DES-1228/ME:5#
66