D-Link DES-1228/ME Reference Manual page 166

config link_aggregation algorithm
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure link aggregation algorithm for mac-source-dest:
DES-1228/ME:5#config link_aggregation algorithm mac_source_dest
Command: config link_aggregation algorithm mac_source_dest
Success.
DES-1228/ME:5#
show link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Used to configure the link aggregation algorithm.
config link_aggregation algorithm [mac_source | mac_destination |
mac_source_dest | ip_source | ip_destination | ip_source_dest]
This command is used to configure the part of the packet examined by the
Switch when selecting the egress port for transmitting load-sharing data.
This feature is only available using the address-based load-sharing
algorithm.
mac_source − Indicates that the Switch should examine the MAC source
address.
mac_destination − Indicates that the Switch should examine the MAC
destination address.
mac_source_dest − Indicates that the Switch should examine the MAC
source and destination addresses
ip_source − Indicates that the Switch should examine the IP source
address.
ip_destination − Indicates that the Switch should examine the IP
destination address.
ip_source_dest − Indicates that the Switch should examine the IP source
and destination addresses
Only Administrator level, Operator level or Power User level users can
issue this command.
Used to display the current link aggregation configuration on the
Switch.
show link_aggregation {group_id <value> | algorithm}
This command is used to display the current link aggregation
configuration of the Switch.
<value> − Specifies the group ID. The Switch allows up to 6 link
aggregation groups to be configured. The group number identifies
each of the groups.
algorithm − Allows users to specify the display of link aggregation
by the algorithm in use by that Switch.
None.
162