D-Link DES-1228/ME Reference Manual page 321

config lldp notification_interval
Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To change the notification interval:
DES-1228/ME:5# config lldp notification_interval 10
Command: config lldp notification_interval 10
Success.
DES-1228/ME:5#
config lldp ports notification
Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To change the port SNMP notification state:
DES-1228/ME:5# config lldp ports 1-5 notification enable
Command: config lldp ports 1-5 notification enable
Success.
DES-1228/ME:5#
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Used to configure the timer of the notification interval used to send
notifications to configured SNMP trap receiver(s).
config lldp notification_interval <sec 5 - 3600>
Globally change the interval between successive LLDP change
notifications generated by the switch.
notification_interval - The range is from 5 second to 3600 seconds. The
default setting is 5 seconds.
Only Administrator level, Operator level or Power User level users can
issue this command.
Used to configure each port for sending notifications to configured SNMP
trap receiver(s).
config lldp ports [<portlist>|all] notification [enable | disable]
Enable or disable each port for sending change notifications to
configured SNMP trap receiver(s) if an LLDP data change is detected in
an advertisement received on the port from an LLDP neighbor. The
definition of change includes new available information, information
timeout and information update. The changed type includes any data
update /insert/remove.
<portlist> - Specify a range of ports to be configured.
all - To set all ports in the system, use the "all" parameter.
notification - Enables or disables the SNMP trap notification of LLDP data
changes detected on advertisements received from neighbor devices.
The default notification state is disabled.
Only Administrator level, Operator level or Power User level users can
issue this command.
317