D-Link DES-1228/ME Reference Manual page 39

config greeting _message
Purpose Used to configure the login banner (greeting message).
Syntax config greeting _message {default}
Description Users can use this command to modify the login banner (greeting message).
Parameters
default – If the user enters default to the modify banner command, then the banner will be
reset to the original factory banner.
To open the Banner Editor, click Enter after typing the config greeting_message command.
Type the information to be displayed on the banner by using the commands described on
the Banner Editor:
Quit without save:
Save and quit:
Move cursor:
Delete line:
Erase all setting:
Reload original setting:
Restrictions Only Administrator level users can issue this command. Other restrictions include:
If the "reset" command is executed, the modified banner will remain modified. However, the
"reset config/reset system" command will reset the modified banner to the original factory
banner.
The capacity of the banner is 24*80. 24 Lines and 80 characters per line.
Ctrl+W will only save the modified banner in the DRAM. Users need to type the "save
config/save all" command to save it into Flash.
Only valid in threshold level.
Example usage:
To modify the banner:
DES-1228/ME:5#config greeting_message
Command: config greeting_message
Greeting Messages Editor
================================================================================
Copyright(C) 2012 D-Link Corporation. All rights reserved.
================================================================================
<Function Key>
Ctrl+C Quit without save
Ctrl+W Save and quit
-------------------------------------------------------------------------------
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Ctrl+C
Ctrl+W
Left/Right/Up/Down
Ctrl+D
Ctrl+X
Ctrl+L
DES-1228/ME Metro Ethernet Switch
Command Line Interface
Firmware: Build 2.01.001
<Control Key>
left/right/
Ctrl+D
Ctrl+X
Ctrl+L
up/down Move cursor
Delete line
Erase all setting
Reload original setting
35