D-Link DES-1228/ME Reference Manual page 135

Example usage:
To configure traffic control and enable broadcast storm control for ports 1 to 12:
DES-1228/ME:5#config traffic control 1-12 broadcast enable action shutdown
threshold 64 countdown 10 time_interval 10
Command:
threshold 64 countdown 10 time_interval 10
Success.
DES-1228/ME:5#
show traffic control
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display traffic control setting for ports 1 to 4:
DES-1228/ME:5#show traffic control 1-4
Command: show traffic control 1-4
Traffic Storm Control Trap :[None]
Port Thres Broadcast Multicast Unicast
hold
---- ----- --------- --------- -------- -------- ----- --------
1 64
2 64
3 64
4 64
Total Entries
DES-1228/ME:5#
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
config traffic control
Used to display current traffic control settings.
show traffic control { <portlist> }
This command is used to display the current storm traffic control
configuration on the Switch.
<portlist> − Used to specify port or list of ports for which to display
traffic control settings. The beginning and end of the port list range are
separated by a dash.
None.
Storm Storm
Disabled Disabled
Disabled Disabled
Disabled Disabled
Disabled Disabled
: 4
1-12 broadcast
Action Count Time
Storm down
Disabled drop 0
Disabled drop 0
Disabled drop 0
Disabled drop 0
131
enable action shutdown
Interval
5
5
5
5