Loopback Detection Commands - D-Link xStack DES-3200 Series Reference Manual

xStack® DES-3200 Series Layer 2 Ethernet Managed Switch CLI Reference Manual
The Loopback Detection commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table:
Command
config loopdetect
config loopdetect ports
enable loopdetect
disable loopdetect
show loopdetect
show loopdetect ports
config loopdetect trap
Each command is listed, in detail, in the following sections:
Parameters
{ recover_timer [ 0 | <value 60-1000000> ] | interval < value 1-32767> | mode [ port-based |
vlan-based ] } (1)
[ <portlist> | all ] state [ enable | disable ]
[ <portlist> | all ]
[ none | loop_detected | loop_cleared | both ]
L D
OOPBACK
395
C
ETECTION OMMANDS
47