D-Link DES-1228/ME Reference Manual page 323

Example usage
To enable port 1 to port 2 to manage address entries:
DES-1228/ME:5# config lldp ports 1-2 mgt_addr ipv4 192.168.254.10 enable
Command: config lldp ports 1-2 mgt_addr ipv4 192.168.254.10 enable
Success
DES-1228/ME:5#
config lldp ports basic_tvls
Purpose
Syntax
Description
Parameters
Restrictions
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Used to configure an individual port or group of ports to exclude one or
more of the optional TLV data types from outbound LLDP
advertisements.
config lldp ports [<portlist>|all] basic_tlvs [all | {port_description |
system_name | system_description | system_capabilities}] [enable |
disable]
An active LLDP port on the Switch always includes the mandatory data in
its outbound advertisements. And there are four optional data that can be
configured for an individual port or group of ports to exclude one or more
of these data types from outbound LLDP advertisements. The mandatory
data type includes four basic types of information (end f LLDPDU TLV,
chassis ID TLV, port ID TLV, Time to Live TLV). The mandatory type can
not be disabled. There are also four data types which can be optionally
selected. They are port_description, system_name, system_description,
and system_capability.
<portlist> - Specify a range of ports to be configured.
all - To set all ports in the system, use the "all" parameter.
port_description - This TLV optional data type indicates that LLDP agent
should transmit 'Port Description TLV on the port.
The default state is disabled.
system_name - This TLV optional data type indicates that the LLDP
agent should transmit 'System Name TLV'. The default state is disabled.
system_description - This TLV optional data type indicates that the LLDP
agent should transmit 'System Description TLV'. The default state is
disabled.
system_capabilities - This TLV optional data type indicates that the LLDP
agent should transmit 'System Capabilities TLV'. The system capability
will indicate whether the device provides repeater, bridge, or router
functions, and whether the provided functions are currently enabled. The
default state is disabled.
Only Administrator level, Operator level or Power User level users can
issue this command.
319