D-Link DES-1228/ME Reference Manual page 116

config stp instance_id
Purpose Used to add or delete an STP instance ID.
Syntax config stp instance_id <value 1-8> [add_vlan | remove_vlan] <vidlist>
Description
This command is used to map VIDs (VLAN IDs) to previously configured STP instances on
the Switch by creating an instance_id. A STP instance may have multiple members with the
same MSTP configuration. There is no limit to the number of STP regions in a network but
each region only supports a maximum of five spanning tree instances (one unchangeable
default entry). VIDs can belong to only one spanning tree instance at a time.
<value 1-8> − Enter a number between 1 and 8 to define the instance_id. The Switch
Parameters
supports five STP instances with one unchangeable default instance ID set as 0.
add_vlan – Along with the vid_range <vidlist> parameter, this command will add VIDs to the
previously configured STP instance_id.
remove_vlan − Along with the vid_range <vidlist> parameter, this command will remove VIDs
to the previously configured STP instance_id.
<vidlist> − Specify the VID range from configured VLANs set on the Switch. Supported VIDs
on the Switch range from ID number 1 to 4094.
Restrictions Only Administrator level, Operator level or Power User level users can issue this command.
Example usage:
To configure instance ID 2 to add VID 10:
DES-1228/ME:5#config stp instance_id 2 add_vlan 10
Command: config stp instance_id 2 add_vlan 10
Success.
DES-1228/ME:5#
Example usage:
To remove VID 10 from instance ID 2:
DES-1228/ME:5#config stp instance_id 2 remove_vlan 10
Command: config stp instance_id 2 remove_vlan 10
Success.
DES-1228/ME:5#
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Note: Switches in the same spanning tree region having the same STP
instance_id must be mapped identically, and have the same configuration
revision_level number and the same name.
112