D-Link DES-1228/ME Reference Manual page 190

config dhcp_relay add ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To add an IP destination to the DHCP relay table:
DES-1228/ME:5#config dhcp_relay add ipif System 10.58.44.6
Command: config dhcp_relay add ipif System 10.58.44.6
Success.
DES-1228/ME:5#
config dhcp_relay delete ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete an IP destination from the DHCP relay table:
DES-1228/ME:5#config dhcp_relay delete ipif System 10.58.44.6
Command: config dhcp_relay delete ipif System 10.58.44.6
Success.
DES-1228/ME:5#
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Used to add an IP destination address to the switch's DHCP/BOOTP
relay table.
config dhcp_relay add ipif [System] <ipaddr>
This command is used to add an IP address as a destination to
forward (relay) DHCP/BOOTP relay packets to.
[System] − The name of the IP interface in which DHCP relay is to be
enabled.
<ipaddr> − The DHCP server IP address.
Only Administrator level, Operator level or Power User level users can
issue this command.
Used to delete one or all IP destination addresses from the Switch's
DHCP/BOOTP relay table.
config dhcp_relay delete ipif [System] <ipaddr>
This command is used to delete an IP destination addresses in the
Switch's DHCP/BOOTP relay table.
[System] − The name of the IP interface that contains the IP address
below.
<ipaddr> − The DHCP server IP address.
Only Administrator level, Operator level or Power User level users can
issue this command.
186