Igmp Snooping Commands - D-Link DES-1228/ME Reference Manual

The IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table:
Command
config igmp_snooping
config igmp_snooping querier
config router_ports
config router_ports_forbidden
enable igmp_snooping
show igmp_snooping
disable igmp_snooping
show router_ports
show igmp_snooping group
config igmp_snooping
data_driven_learning
config igmp_snooping
data_driven_learning
max_learned_entry
clear igmp_snooping data_
driven _group
show igmp_snooping host
config igmp
access_authentication ports
show igmp
access_authentication ports
show igmp_snooping
forwarding
Each command is listed, in detail, in the following sections:
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameters
[vlan_name <vlan_name 32> | vlanid <vidlist> | all] {state [enable | disable] |
fast_leave [enable | disable]} (1)
[vlan_name <vlan_name 32> | vlanid <vidlist> | all] {query_interval <sec 1-
65535> | max_response_time <sec 1-25> | robustness_variable <value 1-
255> | last_member_query_interval <sec 1-25> | state [enable | disable] |
version <value 1-3>} (1)
[<vlan_name 32> | vlanid <vidlist>] [add | delete] <portlist>
[<vlan_name 32> | vlanid <vidlist>] [add | delete] <portlist>
{forward_mcrouter_only}
{vlan <vlan_name 32> } | vlanid <vidlist>}
{forward_mcrouter_only}
{[vlan <vlan_name 32> | vlanid <vidlist>]} {[static | dynamic | forbidden]}
{[vlan <vlan_name 32> | vlanid <vidlist>]} {data_driven}
[vlan_name <vlan_name 32> | vlanid <vidlist> | all] {aged_out [enable |
disable]} (1)
<value 1-64>
[all | [vlan_name <vlan_name 32> | vlanid <vlanid> ] [<ipaddr>] | all]
{[vlan <vlan_name 32> | vlanid <vidlist> | ports <portlist> | group <ipaddr>] }
[<portlist> | all] state [enable | disable]
[all | <portlist>]
IGMP S
NOOPING
172
19
C
OMMANDS