D-Link DES-1228/ME Reference Manual page 230

Example usage:
To show the CPU filtering state on the Switch:
DES-1228/ME:5#show cpu_access_profile
Command: show cpu_access_profile
CPU Interface Filtering state: Enabled
Access Profile Table
================================================================================
Profile ID: 1
================================================================================
Owner: ACL
Masks Option
VLAN
---------------- --------------- --------------- ---- ---- ---- ----
0xFFF
--------------------------------------------------------------------------------
Access ID : 3
Ports : 1-10
Mode : Deny
VLAN Name
Mask
---------------- --------------- --------------- ---- ---- ---- ----
default (0x1)
================================================================================
Total Profile Entries: 1
Total Rule Entries: 1
enable cpu_interface_filtering
Purpose
Syntax
Description
Parameters
Restrictions
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Source IP Dest. IP
20.0.0.0 10.0.0.0
Source IP Dest. IP
Mask Mask
20.0.0.0 10.0.0.0
Used to enable CPU interface filtering on the Switch.
enable cpu_interface_filtering
This command is used, in conjunction with the disable
cpu_interface_filtering command below, to enable and disable CPU
interface filtering on the Switch.
None.
Only Administrator level, Operator level or Power User level users can
issue this command.
Type: IPv4 Frame Filter - ICMP
DSCP Prot Type Code
ICMP
DSCP Prot Type Code
3 ICMP 11
226
32