D-Link DES-1228/ME Reference Manual page 173

enable autoconfig
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable auto configuration on the Switch:
DES-1228/ME:5#enable autoconfig
Command: enable autoconfig
Success.
DES-1228/ME:5#
disable autoconfig
Purpose
Syntax
Description
Parameters
Restrictions
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Used to activate the auto configuration function for the Switch. This
will load a previously saved configuration file for current use.
enable autoconfig
When autoconfig is enabled on the Switch, the DHCP reply will
contain a configuration file and path name. It will then request the
file from the TFTP server specified in the reply. When autoconfig is
enabled, the ipif settings will automatically become DHCP client.
None.
When autoconfig is enabled, the Switch becomes a DHCP client
automatically (same as: config ipif System dhcp). The DHCP server
must have the TFTP server IP address and configuration file name,
and be configured to deliver this information in the data field of the
DHCP reply packet. The TFTP server must be running and have
the requested configuration file in its base directory when the
request is received from the Switch. Consult the DHCP server and
TFTP server software instructions for information on loading a boot
file or configuration file.
Only Administrator level or Operator level users can issue this
command.
NOTE: More detailed information for this command and related commands
can be found in the section titled Switch Utility Commands.
Used to disable DHCP auto configuration.
disable autoconfig
This command is used to disable the DHCP auto configuration
function.
None.
Only Administrator level or Operator level users can issue this
command.
169