Link Aggregation Commands - D-Link DES-1228/ME Reference Manual

The Link Aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table:
Command
create link_aggregation
delete link_aggregation
config link_aggregation
config link_aggregation
algorithm
show link_aggregation
config lacp_ports
show lacp_ports
Each command is listed, in detail, in the following sections:
create link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a link aggregation group:
DES-1228/ME:5#create link_aggregation group_id 1
Command: create link_aggregation group_id 1
Success.
DES-1228/ME:5#
DES-1228/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameters
group_id <value> {type [lacp | static]}
group_id <value>
group_id <value> {master_port <port> | ports <portlist> | state [enable |
disable]} (1)
[mac_source | mac_destination | mac_source_dest|ip_source |
ip_destination | ip_source_dest]
{group_id <value> | algorithm}
<portlist> mode [active | passive]
{<portlist>}
Used to create a link aggregation group on the Switch.
create link_aggregation group_id <value> {type[lacp | static]}
This command is used to create a link aggregation group with a unique
identifier.
<value> − Specifies the group ID. The Switch allows up to 6 link
aggregation groups to be configured. The group number identifies each
of the groups.
type – Specify the type of link aggregation used for the group. If the type
is not specified the default type is static.
lacp – This designates the port group as LACP compliant. LACP allows
dynamic adjustment to the aggregated port group. LACP compliant ports
may be further configured (see config lacp_ports). LACP compliant must
be connected to LACP compliant devices.
static – This designates the aggregated port group as static. Static port
groups can not be changed as easily as LACP compliant port groups
since both linked devices must be manually configured if the
configuration of the trunk group is changed. If static link aggregation is
used, be sure that both ends of the connection are properly configured
and that all ports have the same speed/duplex settings.
Only Administrator level, Operator level or Power User level users can
issue this command.
L A
INK GGREGATION
160
17
C
OMMANDS