Link Aggregation Commands - D-Link xStack DGS-3300 User Manual

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
The link aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
create link_aggregation
delete link_aggregation
config link_aggregation
config link_aggregation
algorithm
show link_aggregation
config lacp_port
show lacp_port
Each command is listed, in detail, in the following sections.
create link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a link aggregation group:
L
INK
Parameters
group_id <value 1-32> {type [lacp | static]}
group_id <value 1-32>
group_id <value1-32> {master_port <port> | ports <portlist>
state [enable | disable]}
[mac_source | mac_destination | mac_source_dest | ip_source
| ip_destination | ip_source_dest]
{group_id <value 1-32> | algorithm}
<portlist> mode [active | passive]
{<portlist>}
Used to create a link aggregation group on the Switch.
create link_aggregation group_id <value 1-32> {type [lacp |
static]}
This command will create a link aggregation group with a unique
identifier.
<value 1-32> − Specifies the group ID. The Switch allows up to 32
link aggregation groups to be configured. The group number
identifies each of the groups.
type – Specify the type of link aggregation used for the group. If
the type is not specified the default type is static.
lacp – This designates the port group as LACP compliant.
LACP allows dynamic adjustment to the aggregated port
group. LACP compliant ports may be further configured (see
config lacp_ports). LACP compliant must be connected to
LACP compliant devices.
static – This designates the aggregated port group as
static. Static port groups can not be changed as easily as
LACP compliant port groups since both linked devices must
be manually configured if the configuration of the trunked
group is changed. If static link aggregation is used, be sure
that both ends of the connection are properly configured and
that all ports have the same speed/duplex settings.
Only administrator-level users can issue this command.
126
A
GGREGATION
16
C
OMMANDS