Link Aggregation Commands - D-Link DGS-3224TGR Command Line Interface Reference Manual

The link aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
create
link_aggregation
delete
link_aggregation
config
link_aggregation
config
link_aggregation
algorithm
show link_aggregation
config lacp_ports
show lacp_ports
Each command is listed, in detail, in the following sections.
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
L A
INK GGREGATION
Parameters
group_id <value 1-32>{type [lacp|static]}
group_id <value 1-32>
group_id <value 1-32>
{master_port <port>|
ports <portlist>
state [enable|disable]}
[mac_source|
mac_destination|
mac_source_dest
ip_source
ip_destination
ip_source_dest
group_id <value 1-32>
algorithm
<portlst> mode [active|passive]
{<portlist>}
82
17
C
OMMANDS