Changing The Paper Size In The Optional Paper Tray Unit (Tray 2 And Tray 3) - Ricoh 920F Operating Instructions Manual

Changing the Paper Size in the Optional Paper Tray Unit (Tray 2 and Tray 3)

This section describes how to change the paper size in the optional paper tray unit (Tray 2 and Tray 3).
• If a paper tray is pushed vigorously when putting it back into place, the position of the tray's side
fences may slip out of place.
• Do not stack paper over the limit mark.
• Check the paper edges are aligned with the right side.
1. Check that paper in the paper tray is not being used, and then pull the tray carefully out
until it stops.
2. Remove paper if loaded.
3. While pressing down the release lever, slide the side fence until it is aligned with the paper
size you want to load.
Make sure there are no gaps between the paper and side fence.
4. While pinching the release levers, slide the end fence until it is aligned with the paper size
you want to load.
Make sure there are no gaps between the paper and end fence.
BRA026S
BRA027S
Changing the Paper Size
71
3