Lldp Admin-Status; Lldp Basic-Tlv Management-Ip-Address - Edge-Core ECS4810-12M Layer 2 Management Manual

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

This command enables LLDP transmit, receive, or transmit and receive

lldp admin-status

mode on the specified port. Use the no form to disable this feature.

Interface Configuration (Ethernet, Port Channel)

This command configures an LLDP-enabled port to advertise the

lldp basic-tlv

management address for this device. Use the no form to disable this

management-ip-

Interface Configuration (Ethernet, Port Channel)

lldp admin-status {rx-only | tx-only | tx-rx}

no lldp admin-status

rx-only - Only receive LLDP PDUs.

tx-only - Only transmit LLDP PDUs.

tx-rx - Both transmit and receive LLDP Protocol Data Units (PDUs).

Console(config)#interface ethernet 1/1

Console(config-if)#lldp admin-status rx-only

Console(config-if)#

[no] lldp basic-tlv management-ip-address

The management address protocol packet includes the IPv4 address of

the switch. If no management address is available, the address should

be the MAC address for the CPU or for the port sending this

advertisement.

The management address TLV may also include information about the

specific interface associated with this address, and an object identifier

indicating the type of hardware component or protocol entity associated

with this address. The interface number and OID are included to assist

SNMP applications to perform network discovery by indicating

| LLDP Commands