Logging Sendmail; Logging Sendmail Host - Edge-Core ES3510MA-DC Management Manual

| System Management Commands
C 21
HAPTER
SMTP Alerts

logging sendmail

logging sendmail
host
This command enables SMTP event handling. Use the no form to disable
this function.
S
YNTAX
[no] logging sendmail
D S
EFAULT ETTING
Enabled
C M
OMMAND ODE
Global Configuration
E
XAMPLE
Console(config)#logging sendmail
Console(config)#
This command specifies SMTP servers that will be sent alert messages. Use
the no form to remove an SMTP server.
S
YNTAX
[no] logging sendmail host ip-address
ip-address - IP address of an SMTP server that will be sent alert
messages for event handling.
D S
EFAULT ETTING
None
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
◆ You can specify up to three SMTP servers for event handing. However,
you must enter a separate command to specify each server.
To send email alerts, the switch first opens a connection, sends all the
◆
email alerts waiting in the queue one by one, and finally closes the
connection.
To open a connection, the switch first selects the server that
◆
successfully sent mail during the last connection, or the first server
configured by this command. If it fails to send mail, the switch selects
the next server in the list and tries to send mail again. If it still fails, the
system will repeat the process at a periodic interval. (A trap will be
triggered if the switch cannot successfully open a connection.)
– 552 –