Smtp Alert Commands; Logging Sendmail Host; Table 23-12 Smtp Alert Commands - Edge-Core ES4626F Management Manual

23
System Management Commands
Example
The following example shows the event message stored in RAM.
Console#show log ram
[1] 00:01:30 2001-01-01
"VLAN 1 link-up notification."
level: 6, module: 5, function: 1, and event no.: 1
[0] 00:01:30 2001-01-01
"Unit 1, Port
level: 6, module: 5, function: 1, and event no.: 1
Console#

SMTP Alert Commands

These commands configure SMTP event handling, and forwarding of alert
messages to the specified SMTP servers and email recipients.
Command

logging sendmail host

logging sendmail level
logging sendmail
source-email
logging sendmail
destination-email
logging sendmail
show logging sendmail
logging sendmail host
This command specifies SMTP servers that will be sent alert messages. Use the no
form to remove an SMTP server.
Syntax
[no] logging sendmail host ip_address
ip_address - IP address of an SMTP server that will be sent alert
messages for event handling.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• You can specify up to three SMTP servers for event handing. However, you
must enter a separate command to specify each server.
23-32
1 link-up notification."

Table 23-12 SMTP Alert Commands

Function
SMTP servers to receive alert messages
Severity threshold used to trigger alert messages
Email address used for "From" field of alert messages
Email recipients of alert messages
Enables SMTP event handling
Displays SMTP event handler settings
Mode Page
GC 23-32
GC 23-33
GC 23-33
GC 23-34
GC 23-34
NE, PE 23-35