Configuring A Class Map - Edge-Core ES3528-WDM Management Manual

14
Quality of Service
6. Use the "Service Policy" to assign a policy map to a specific interface.

Configuring a Class Map

A class map is used for matching packets to a specified class.
Command Usage
• To configure a Class Map, follow these steps:
- Open the Class Map page, and click Add Class.
- When the Class Configuration page opens, fill in the "Class Name" field, and
click Add.
- When the Match Class Settings page opens, specify type of traffic for this class
based on an access list, a DSCP or IP Precedence value, or a VLAN, and click
the Add button next to the field for the selected traffic criteria. You can only
specify one item to match when assigning ingress traffic to a class map.
• The class map uses the Access Control List filtering engine, so you must also set
an ACL mask to enable filtering for the criteria specified in the Class Map. See
"Configuring an IP ACL Mask" on page 8-10 or "Configuring a MAC ACL Mask" on
page 8-12 for information on configuring an appropriate ACL mask.
• The class map is used with a policy map (page 14-5) to create a service policy
(page 14-8) for a specific interface that defines packet classification, service
tagging, and bandwidth policing. Note that one or more class maps can be
assigned to a policy map.
Command Attributes
Class Map
• Modify Name and Description – Configures the name and a brief description of
a class map. (Range: 1-32 characters for the name; 1-256 characters for the
description)
• Edit Rules – Opens the "Match Class Settings" page for the selected class entry.
Modify the criteria used to classify ingress traffic on this page.
• Add Class – Opens the "Class Configuration" page. Enter a class name and
description on this page, and click Add to open the "Match Class Settings" page.
Enter the criteria used to classify ingress traffic on this page.
• Remove Class – Removes the selected class.
Class Configuration
• Class Name – Name of the class map. (Range: 1-32 characters)
• Type – Only one match command is permitted per class map, so the match-any
field refers to the criteria specified by the lone match command.
• Description – A brief description of a class map. (Range: 1-256 characters)
• Add – Adds the specified class.
• Back – Returns to previous page with making any changes.
14-2