Figure 13: Setting The Polling Interval For Sntp; Configuring Ntp - Edge-Core ECS4620-28T Quick Start Manual

Setting the SNTP
Use the System > Time (Configure General - SNTP) page to set the polling interval at
which the switch will query the specified time servers.
Polling Interval
Parameters
The following parameters are displayed:
◆
◆
Web Interface
To set the polling interval for SNTP:
1.
2.
3.
4.
5.

Figure 13: Setting the Polling Interval for SNTP

Configuring NTP

Use the System > Time (Configure General - NTP) page to configure NTP
authentication and show the polling interval at which the switch will query the
specified time servers.
Parameters
The following parameters are displayed:
◆
◆
Current Time – Shows the current time set on the switch.
SNTP Polling Interval – Sets the interval between sending requests for a time
update from a time server. (Range: 16-16384 seconds; Default: 16 seconds)
Click System, then Time.
Select Configure General from the Step list.
Select SNTP from the Maintain Type list.
Modify the polling interval if required.
Click Apply
Current Time – Shows the current time set on the switch.
Authentication Status – Enables authentication for time requests and updates
between the switch and NTP servers. (Default: Disabled)
– 99 –
Chapter 3
| Basic Management Tasks
Setting the System Clock