Retrofitting Accessories; Mounting Kit For Headrest Attachment; Mounting Kit For Signal Panel; Rear-View Mirror - Otto Bock Xeno Service Manual

6.16 Retrofitting Accessories

6.16.1 Mounting Kit for Headrest Attachment

The headrest holder is attached to the back frame using an adapter plate.
Tools:
❒ Allen wrench, size 3
❒ Ring wrench or open-end wrench, size 10 mm
Steps:
1. Attach the holder to the top of the back tube with two Allen head screws nuts.
Figure 84 Mounting kit for headrest attachment

6.16.2 Mounting Kit for Signal Panel

The signal panel holder is attached to the back frame using an adapter plate.
Tools:
❒ Allen wrench, size 3
❒ Ring wrench or open-end wrench, size 10 mm
Steps:
1. Attach the holder to the top of the back tube with two Allen head screws nuts.
2. Hook the signal panel in place.

6.16.3 Rear-view mirror

Tools:
❒ Allen wrench, size 3
Steps:
1. Loosen the two set screws on the guide rail on the underside of the armrest.
2. Pull out the guide rail.
3. Insert the rear-view mirror with attached rail into the receiver.
4. Retighten the two set screws.
76