I
L
Fig. 30
Main cable with connected micro-switch and Installed micro-switch
Fig. 31
Controller with connected main cable and Charging and programming receptacle
6.11.1 Programming
To be able to use the lift seat, it is first necessary to programme the control unit:
1. Connect the handheld programming device to the charging and programming receptacle of
the hand control device (see item N).
2. For the subsequent steps, see the enAble50 instructions for use (order number 647G490).
6.12 Retrofitting the seat module (lift seat/seat tilt/back)
NOTICE
Risk of damage due to a lack of technical knowledge. For information on connecting the seat
module, see section 8.3.
Controlling more than three electric seat functions requires the installation of a seat module.
The seat module should be installed on a metal brace below the seat (included in the scope of
delivery).
Skippi Plus
N
M
Service Work
K
J
N
Ottobock | 33