Changing The Fuse Of The Fuel Pump - Husqvarna FC 350 2023 Owner's Manual

Table of Contents

Advertisement

14 ELECTRICAL SYSTEM
14.5
108
F03751-10
F03752-10

Changing the fuse of the fuel pump

Warning
Fire hazard Incorrect fuses overload the electrical system.
Only use fuses with the required ampere value.
Do not bypass or repair fuses.
Caution
Danger of burns The voltage regulator gets very hot when the vehicle is driven.
Allow the voltage regulator to cool down before performing any work.
Info
The fuel pump is protected by the fuel pump fuse. This is located under the seat.
Remove the fuel tank.
Main work
1
Pull starter relay
from the holder.
Take off protection caps
Remove faulty main fuse
Info
A faulty fuse has a burned-out fuse wire
4
A spare fuse
is located in the starter relay.
Insert a new main fuse.
Fuse (58011109110) (
Check that the electrical system is functioning properly.
Tip
Insert a spare fuse so that it is available if needed.
Mount the protection caps.
Mount the starter relay onto the holder and route the cable.
Finishing work
Install the fuel tank.
(
Install the right side panel. (
Mount the seat. (
p. 66)
(
p. 73)
2
.
3
.
A
.
p. 137)
p. 75)
p. 71)

Advertisement

Table of Contents
loading

Table of Contents