Fuel Pump Removal; Cock Removal - Husqvarna TC 449 2011 I.E. Workshop Manual

3
2
1
2
Workshop Manual Ed. 03-2012
GENERAL PROCEDURES
TC 449 2011/2012 I.E.
TE 449 - 511 2011/2012 I.E.
TXC 449 - 511 2011/2012 I.E.
SMR 449 2011 I.E.
SMR 511 2011/2012 I.E.

Fuel Pump Removal

- Remove lower fuel tank as described in the relevant paragraph.
- Using a 8 mm Allen wrench, loosen the five screws (1) securing pump (2) to
tank.
- To replace throttle body supply hose (3), open metal clamp (4) and then,
after hose replacement, close clamp again using the special pliers.
1
4
H02426
On reassembly, tighten screws (1) to a torque of 7 Nm - 0.7 Kgm -
8
5.16 ft/lb checking that the O-ring (8) is correctly positioned in its
seat and it is not damaged.
H02427

Cock Removal

- Remove lower fuel tank as described in the relevant paragraph.
- Using a Phillips screwdriver, loosen screws (1), then remove cock (2).
1
H02429
On reassembly, check O-ring (3) correct positioning.
3
H02428
E.14