Changing The Fuse Of The Fuel Pump - Husqvarna FC 450 2023 Owner's Manual

14 ELECTRICAL SYSTEM
14.5
108
F03751-10
F03752-10

Changing the fuse of the fuel pump

Warning
Fire hazard Incorrect fuses overload the electrical system.
–
Only use fuses with the required ampere value.
–
Do not bypass or repair fuses.
Caution
Danger of burns The voltage regulator gets very hot when the vehicle is driven.
–
Allow the voltage regulator to cool down before performing any work.
Info
The fuel pump is protected by the fuel pump fuse. This is located under the seat.
–
Remove the fuel tank.
Main work
–
1
Pull starter relay from the holder.
–
Take off protection caps
–
Remove faulty main fuse
Info
A faulty fuse has a burned-out fuse wire
4
A spare fuse is located in the starter relay.
–
Insert a new main fuse.
Fuse (58011109110) (
–
Check that the electrical system is functioning properly.
Tip
Insert a spare fuse so that it is available if needed.
–
Mount the protection caps.
–
Mount the starter relay onto the holder and route the cable.
Finishing work
–
Install the fuel tank. (
–
Install the right side panel. (
–
Mount the seat. ( p. 67)
( p. 73)
2
.
3
.
A
.
p. 139)
p. 74)
p. 55)